Gas heater PTPG-30M - Projects «Bunter Group»

Projects Gas heater PTPG-30M

Year
2021
Category
Oil and gas equipment

Pre-commissioning works and mode adjustment of start-up and fuel gas heater PTPG-30M manufactured by Bunter Group has been carried out.

The heater is designed to preheat the associated gas supplied to the field gas gathering station site prior to the pressure reduction process.

Rated heater capacity – 30,000 nm3/h;
Heated product pressure – 7.5 MPa;
Rated power of the heater – 1.1 MW.
Inlet and outlet temperature difference – 70 deg.
Efficiency – 82 %

A multiflow U-shaped pipe bundle is installed in the heater housing to provide the specified pressure difference and normative values of the medium flow rate. The heater is equipped with a specially designed smoke pipe of an increased height to provide a consistent draft for stable operation of the furnace path devices and thermal power. The smoke pipe is equipped with stretching braces and brackets for on-site installation to ensure additional stability.

The gas control unit built into the heater is equipped with a gas metering unit and rotary gas meter for auxiliaries.

Would you like to discuss your project?

Our team is ready to implement a project of any complexity.
If you have assignments or questions, leave a request and we will contact you as soon as possible

Other projects
2019 year
This is an auxiliary unit for operation of the main equipment of booster compressor station (BCS).
2018 year
The customer needed an oil treatment unit with heating of the incoming products.
According to the terms of reference, our scientific and technical center has proposed a unit with a volume of V = 115 m3.
2021 year
Newly designed indirect heater has been manufactured and shipped to the Customer.
2021 year
Heater with intermediate coolant PPT-0.2G designed for heating oil emulsions in oil collection and transportation systems, as well as natural or associated gas and waste field water at gas-distributing units of gas-lift oil production system, has been manufactured and shipped to the Customer.
2016 year
Four sets of KDFT pipe end phase dividers designed for separation of well production and formation water treatment to the required standards were supplied.

На этом веб-сайте используются файлы cookie, которые обеспечивают работу всех функций для наиболее эффективной навигации по странице. Если вы не хотите принимать постоянные файлы cookie, пожалуйста, выберите соответствующие настройки на своем компьютере. Продолжая навигацию по сайту, вы предоставляете свое согласие на использование файлов cookie на этом веб-сайте. Более подробная информация предоставляется в нашей политике конфиденциальности